Fluidhaus LLC

hydraulic gear motor or pump 9 tooth shaft 8-26 cc/rev (0.732-1.58 in3/rev) 2-18gpm bi-direction sae a mount

valve stacking 90 degree block

valve stacking blocks parallel for sco power unit, d03 (ng6) mounting pattern

hydraulic directional control valve cartridge c-08-2 common cavity, 2-position 2-way, 24vdc 2-pin deutsch connector sae -6 ports

hydraulic filter d03 (ng6) mounting, 8 gpm, 4600 psi, 20 micron

hydraulic parallel valve manifold aluminum d05 ng10 (1-6 station), mpa10 series

pfeg pump shaft seal, 7/8" keyed shaft

240/480vac 3 phase hydraulic power unit 2hp 1-4 gpm 800-3000 psi 50 or 60hz valves optional

vertical hydraulic power unit, 3.5 gpm, 3100 psi, 2 hp 110/220vac 1 phase 5/60hz motor, 5 gallon tank

hydraulic parallel valve manifold aluminum d05 ng10 (1-6 station), mpa10 series npt

hydraulic proportional valve amplifier card, +/- 10vdc or 4-20ma, single and double solenoid

230/460vac 3 phase 3hp 60hz vertical hydraulic power unit, 1-3.5gpm, 3100 psi, 5 gallon tank

d05 ng10 valve 3 position with manual lever. closed center

cable assembly for hydraulic single or double solenoid valve din 46350 form a 18mm pur polyurethane outdoor rated 12vdc 24vdc 110vac or 220vac

float switch, hydraulic, normally closed, dc/ac, low level with din 46350 form a 18mm connector

d03 (ng6) or d05 (ng10): hydraulic electrical solenoid valve with manual override: 18 gpm: 4560 psi: 12vdc 24vdc 110vac, deutsch 2-pin connector

proportional pressure control valve, <650 psi for pilot control, d03/ng6 mounting, with and without electronics

filler breather cap with dip stick, for sco power units

d05 explosion proof valve, 3 position closed center, 24vdc with manual lever, 4500 psi

proportional valve, d05, d07 or d08 (ng10, ng16, ng25) 2-stage without electronics