Wireless Water Tank Full Sensor for Remote Water Pump Shutoff

Wireless Water Tank Sensor for Remote Pump Shutoff Why use a Wireless Water Tank Sensor? Finally, you can avoid trenching for thousands of feet of tank full sensor wire in order to shut off your pump remotely when the tank is full!  After years of customer requests and development, comes an easy-to-use wireless tank full sensor.  No more trenching, no more running hundreds of feet of wire, no more damaged underground wires!  It just works.  Now compatible with AC pumps! The AC options come with 30A 120V/240V AC contactors to control large loads to run any motor up to 5HP. The transmitter uses a solar panel and battery to ensure power without having to get power to where your tank is located, receiver ties into the power from the pump. Connect the float switch to the transmitter unit and your ready to go! The signal has been tested up to 2.5 miles and could potentially reach 5+ miles with the right antenna mounting location. The signal can travel through trees and other objects that can obscure the actual line of sight. However, the signal can not travel between two valleys with a mountain or hill in between. The system has been tested at over 2.5 miles (!) line of sight (moderately flat land with trees and building in-between, will not work between two valleys with large hills blocking the signal). Transmitter unit is installed at Water Tank, to send signal to receiver when tank is full. Receiver unit Installed next to RPS Pump. Kit Contents AC Pump Control *AC pumps only* Transmitter with Antenna Receiver with Antenna Float Switch Solar Panel  Mounting bracket Hardware Battery at transmitter unit Contactor with weatherproof enclosure at receiver unit Ready to Ship! 2 Year Warranty