VTT Plug and Play Wireless Xdrive Controller

Looking for a way to do burnouts in your ATC13-2 Equipped Xdrive BMW that doesn’t have an RWD mode such as G-Series non-M vehicles, and SUVs? We were too! VTT is proud to offer the ONLY easy-to-install, plug, and-play Xdriove controller on the market. This device will allow you to turn off, and turn on again your X-drive capability from the driver seat with a remote. While other options do exist such as X-Delete, or an in-dash gauge, one is a very slow process and is not viable to use as a way to do a burnout at the drag strip, and the other is a very expensive, AND very intrusive device that requires removal of most of the dash, and installing a gauge. Our solution takes 30 seconds to install once you gain access to the underside of the vehicle, and can be removed just as easily. Once installed, you can remotely disable your Xdrive from the driver’s seat to perform your burnout, and then quickly enable it again to perform your launch with AWD active. This action does NOT require a key cycle, as soon as you activate it again the car will dismiss any lights and codes generated. This truly is the best of both worlds for ease of use, practicality, and effectiveness, all while coming at a very affordable price. This device uses a BMW plug on one end, and our custom-printed male plug on the other, for a plug, and play OEM fit. NO cutting any wires! PLEASE NOTE: WE ONLY SUGGEST USING THE DEVICE FOR SHORT PERIODS OF TIME, SUCH A BURNOUT AT THE STAGING AREA OF A DRAG RACE. IN SOME INSTANCES, THE CAR WILL NOT ALLOW A BURNOUT IF THE BRAKE, AND THROTTLE ARE APPLIED AT THE SAME TIME DUE TO ECU LOGIC, IN THESE INSTANCES INSTALLING OUR WIRELESS LINE LOCK ELIMINATES THIS ISSUE. MANY TIMES AN AFTERMARKET TUNE WILL ALSO ELIMINATE THIS ISSUE. THIS DEVICE CAN BE USED FOR THINGS SUCH AS DRIFTING DONUTS ETC., BUT WE DO NOT CONDONE ANY DRIVING OUTSIDE OF LEGAL GUIDELINES. PLEASE USE THIS PRODUCT RESPONSIBLY Install/User Guide is here – Install Guide Features: Works on any vehicle outlined below from stock to tuned 30-second install 30-second removal NON-intrusive ZERO cutting of wires, or taking anything apart on the vehicle TRULY plug and play OEM fit and finish on the plugs Warranty: 12 Months Make your burn outs even easier with our wireless Line Lock kit, and get 5% off! VTT BMW Wireless Plug, and Play Line Lock Kit VTT is proud to offer a truly plug-and-play line lock kit for select BMW vehicles that does NOT require running wiring inside the car, mounted switches, holes in the dash, etc. Our newly designed and released line lock kits use a 40amp wireless remote control switch with 4 different modes that allow you to tailor your line lock setup exactly as you prefer. You simply install the solenoids, install the harness with the switch which has all the wiring terminated, bleed the brakes, and you are ready for effortless burnouts which will not be interfered with by the DME because you are holding the brakes, nor wear your rear brake pads. You can store the remote anywhere in your vehicle, center console, cup holder, door cup holder, etc., and when you need to do a burnout to heat your race tires it's in arm's reach without running any wiring into the vehicle. Fitment is confirmed for G8X M3/4, A9X Supra - The kit itself including lines, solenoids, etc will fit most all late model BMW Chassis including F8X, F3X, G2X, etc. The main concern will be mounting the wireless switch in the passenger cowl area. The kit includes: Line lock solenoids with weather pack connectors Two Parker 90-degree -3 an fittings Two Stainless Steel adapter fittings Two DOT Approved Stainless Steel brake lines One complete wiring harness One Remote control switch with TWO remotes