TX AP Stabilizers Top Clip-in

TX Top Clip-in Stabilizers utilize TX's AP construction with an added feature of being a "top clip-in" mount to the PCB. This allows for a more secure hold onto the PCB so that the stabilizer doesn't become loose and also is easier to mount or remove the stabilizer by not needing to turn over the PCB. Please check compatibility plates below. TX AP Stabilizers Top Clip-in Features: Designed by kin25 Top Clip-in Stabilizers Secured onto the PCB via top clip-in Doubleshot Stem POM Outside TPU & POM Inside Supports both 6.25U and 7U Available in: Type: Base, 2U Color: Black, White Size: 1.6T, 1.2T Includes: Base Set 10 Housings and Stems 4 2U Wires 1 6.25U Wire 1 7U Wire 1 Set Clip-in Wedge 2U Set 6 Housings and Stems 3 2U Wires 1 Set Clip-in Wedge Compatibility (Please read before purchasing): Type A Plate: This plate is widely used and the stabilizer can be used without any interference Type B Plate: This configuration may show up in the spacebar portion of the plate. If may have an interference on the latch part of the wedge (highlighted blue). This part should be cut. Two extra wedges are included. Type C Plate: Top clip-in stabilizers can only be used if the highlighted blue portion of the wedge is cut. Other: In the case where the stabilizer tab of the plate is cut at the same length of the switch cutout, method C can be used to fit the stabilizer. Returns/Refunds as a result of plate compatibility will not be accepted.