Triple Clamp Motoscope Mini Modification

This is to add the motoscope mini cut out, LED's and back panel to your clamp. This is only for Cognito Moto Clamps. This is used for Fixed offset triples, Custom Clamps, or if you have already purchased the motoscope mini prior.   For the indicator lights    LED Wires: Each LED has: A positive wire (colored to match the LED light color). A black wire (for ground). Identifying Black Wires: Use a battery to systematically test each colored wire by connecting it to the positive side of the battery. Check each black wire individually to identify which LED it corresponds with through a process of elimination. Yellow LEDs (Turn Signals) & Blue LED (High Beam): Positive Wire (yellow for turn signals, blue for high beam) should connect to the respective turn signal or high beam circuit. Black Wire connects to ground. Red LED (Oil Light) & Green LED (Neutral Light): Positive Wire (red for oil light, green for neutral light) should connect to a 12V source that is key-switched on (i.e., only powered when the ignition key is on). Black Wire connects to the oil switch and neutral switch, respectively. Note: These LEDs are ground-switched rather than 12V-switched (like the turn signals and high beam), so they activate when grounded.