Trail Series Chassis - Assembled

PLEASE CONTACT FOR CONSULTATION PRIOR TO ORDER, sales@hulseengineering.com ALL ASSEMBLED CHASSIS MUST BE PICKED UP IN GRAND JUNCTION, CO. NO SHIPPING ON ASSEMBLED CHASSIS. CHASSIS KITS NOT STOCKED BUT CUT PER ORDER IN 4-6 WEEKS, AND THEN ANOTHER 1-2 WEEKS FOR JIG ASSEMBLY Trail series rock crawler chassis 2 seat version and 3 seat version Jig Assembled and MIG tac'ed. Chassis is fully jig'ed to ensure everything is 100% correct and then MIG tac'ed, you will still need to fully weld out the chassis yourself. 48” wide chassis Chassis are all 1.75x.120 DOM main tubes with 1.25x.120 inner support bars, subframe and rockers are 1.75”x.188 Each kit is CNC cut, bent, and etched with part numbers and outlines of tube junctions Designed for a 108-112” WB Designed for smaller drivetrains, such as a v6 or turbo 4cyl to allow room for a smaller front radiator, a V8 can tightly fit with a shorter transmission and a rear radiator  Shorter subframe ideally for a Dana 300 and passenger drop, Atlas would fit but require seat above it to be mounted 1-2” higher Driver drop transfer case is not recommended unless driver is smaller height than average male adult, extensive modification to seat to clear transfer case will be required Designed to run all axle styles, portals/Dana 60/14b/etc, recommended to run no less than 68” WMS, 70” WMS is recommended Clearance for front and rear steering Each kit is made to order, as such it will take 4-6 weeks to schedule and get produced at the CNC shop and then 1-2 weeks for assembly. These are estimates though and it could be shorter or longer. Please contact for a consultation prior to placing an order, sales@hulseengineering.com