TheraFace Mask Glo

kTheraFace Mask Glo LED face mask combines 504 red, infrared and blue LED lights with a gentle scalp massage to increase circulation and relieve tension in just 12 minutes a day. Clinically proven to reduce under-eye wrinkles and fine lines, enhance radiance, and lift sagging skin in as little as 8 weeks What's included: TheraFace Mask Glo device Protective eye shield USB-C charging cable Directions Charge the device before use. Begin with a clean, dry face. Do not allow the device to come in contact with colored solids or liquids, as it is hard to clean after being dyed. Remove all makeup, wash hands thoroughly, and ensure that cosmetics (such as lipstick) and oils do not come into contact with the device. Place the device on your face, and adjust both of the Velcro straps to your desired fit. The device should feel snug but not too tight on your face. Press and hold the LED power button to begin a light and vibration treatment. Press and hold the vibration power button to turn on the vibration treatment only. At any point during the light and vibration treatment, press and hold the vibration button to turn off the vibration for light treatment only. Select your desired LED light treatment setting. The device will guide you through a 12-minute science-backed treatment that automatically cycles through three LED light treatment types: red light, red + infrared light, and blue light. Each treatment will be 4 minutes long. Press the LED power button at any point to cycle through light therapy types. You will hear a beep when the light therapy type changes. Select your desired vibration treatment setting. There are two vibrating motors located in the headstrap. Press the vibration button to toggle through the three vibration modes (Relax: low-frequency continuous; Refresh: higher-frequency continuous; and Relieve: wave). Use vibration as a standalone treatment without LED light by pressing and holding the LED button while vibration is on. If vibration is used as a standalone treatment, it will run for 12 minutes. Turn off the device. Press and hold the power button at any point during the treatment to turn off the device. The LED light will turn off when the device is off. The device will automatically shut off after the 12-minute treatment is complete. *This device has built-in eyeshields. Normal use of the eyeshields may result in redness around your eye area. Some redness is normal and should subside within 5-10 minutes of using the device Before using or charging, read all instructions and cautionary markings in this manual, on the charger.