Tetra2Go 4-Port Wi-Fi Pixel Controller

4-Port Pixel Controller (upgradable to 8-Port w/ the Differential Module) Revision 1.1 Wi-Fi support ESP32 Based Expansion header (Ethernet, Differential, and Audio-Reactive Modules available, sold separately) WLED 0.14.0 pre-installed XLights Compatible 5V Data Signal, 33 ohms Modular and repairable Supports 12v & 5v pixels and strip Runs WLED software, pre-installed Supports max of 600 pixels per channel for 40fps (2400 total) 5A MAX per output. (20A Total) (Over 200 LEDs per output should only exceeded only with proper voltage injection) Reverse Polarity Protection* * Make sure to note that the protection circuit only safeguards the controller and not any attached LEDs. Keep in mind that if polarity is reversed, any connected LEDs may still be damaged. After connecting the DC power cable, ALWAYS try to power on the controller without any pixels first to ensure proper polarity. Outputs Port1: GPIO2 Port2: GPIO13 Port3: GPIO12 Port4: GPIO14