Temperature, Pressure, Humidity, and VOC BME680 Wireling

DESCRIPTION This Wireling lets you measure Temperature, Pressure, Humidity, and Volatile Organic Compounds (VOCs) via the BME680. This Wireling sensor is an upgrade from the Pressure & Humidity Wireling that uses the BME280 to measure Pressure and Humidity. New to Wirelings? Check out the Wireling Overview! Note* 5-Pin Wireling cables not included and sold separately. TECH SPECS Bosch BME680 Sensor Specs Digital interface I²C (up to 3.4 MHz) and SPI (3 and 4 wire, up to 10 MHz) Operating range -40 - +85°C, 0-100 % r.H., 300-1100 hPa Humidity, Pressure, Gas sensor can be independently enabled / disabled RoHS compliant, halogen-free, MSL1 Pressure Sensor RMS Noise 0.12 Pa, equiv. to 1.7 cm Offset temperature coefficient ±1.3 Pa/K, equiv. to ±10.9 cm at 1 °C temperature change Humidity Sensor Response time 8 s Accuracy tolerance ±3 % relative humidity Hysteresis ±1.5% relative humidity Gas Sensor Response time < 1s (for new sensors) Power consumption < 0.1mA in ultra-low power mode Output data processing: direct index for air quality (IAQ) output TinyDuino Power Requirements Voltage: 3.0V - 5.5V  Current: 2.1 µA @ 1 Hz humidity and temperature 3.1 µA @ 1 Hz pressure and temperature 3.7 µA @ 1 Hz humidity, pressure, and temperature 0.15 µA in sleep mode Due to the low current, this board can be run using the TinyDuino coin cell option. Pins Used A5/SCL - I²C Serial Clock line A4/SDA - I²C Serial Data line Dimensions 10mm x 10mm (.394 inches x .394 inches) Max Height (from the lower bottom of Wireling to upper top Wireling Connector): 3.70mm (0.15 inches) Weight: 1 gram (.04 ounces) NOTES You can also use this Wireling without the TinyDuino – modifying the connecting cable by removing the opposite connector and stripping/tinning the wires, you can solder the connector cable to any other microcontroller board of your choice!    DOWNLOADS BME680 Datasheet Eagle Files Schematic Arduino Sample Code CAD 3D and 2D Files