TANQ 2 Flying Car Print Set

Our 3D prints are designed and printed by Noozle3d, if you want custom colors of our prints you can contact them directly. Turn your TANQ 2 into a TANK!  From Let's Fly RC: "If you own a Rotor Riot TanQ 2 frame in standard configuration, these files will help you to turn it into a flying car. I have added Screenshots of the Radio Settings in my Zorro, so if you have Edge TX or Open TX and mirror these settings, it will be a good start.  Channel 7 is the left 2 wheels, and Channel 8 is the Right two wheels, or vice versa, I don't remember.   On the ESC, I twisted the signal wires together for the left 2 motors and soldered them to the Motor 5 output wire harness on the flight controller, remapped it to servo 1, and I did the same for the right side on the Motor 6 output of the flight controller, and remapped it to servo 2 (or vice versa, I don't remember).   I used the Tmotor Pro full featured flight controller and I will upload the dump file, which will show you how I addressed the motor pads and remapping.  I enabled Servo Channel Forwarding in CLI, and set the first Servo Channel to channel 7, so that 7 and 8 would be the additional motors.  Then, I output servo signals from the flight controller's motor 5 and 6 as pwm signals to the motors to make them go... The SF switch was used on my Zorro to switch between car and drone mode." STL Files, Flight Controller Dump, Open TX Settings Thingiverse Page   Required Parts (in addition to a complete TANQ 2 Drone) 1x TANQ 2 Tank Mod Print Set 1x T-Motor F7 Pro Flight Controller 1x F55 PRO II 32Bit 55A 3-6S 30x30 4in1 ESC 4x Hypetrain Let's Fly RC 2306 1850kv Motor Includes 4x Motor Mounts 4x Wheels