T ROCK 2

********3D Print Files Only!********* Digital Download Only, 3d Print .stl files *********************************   Is your rig a mall crawler or a Wall Crawler!?!?   Triple Rock 2 (T Rock 2) is over 5" tall which will test out your SCX24 short wheel base rigs and longer rigs will have an advantage. The center is cut out so you don't have to worry about high centering. I scuff mine up with 50grt sand paper to give it a little extra grip where needed. You can also add a tile on the approach to give you a little extra height (I needed it with my SCX24's)     Each tile is 150mm wide (~6") and are interlocked by locking pins underneath.   Join our CRAWLAGON facebook group and show off your builds. ENJOY!!!!    - Designed by Dirt Digg-ler Offroad LLC DBA CRAWLAGON™, all rights reserved, for personal use only, No commercial use.   Printer Settings: - Level your bed properly to avoid locking pin problems. If you have trouble with leveling, try printing with a raft. - Different sized pins are included to compensate for any bed leveling issues and different materials. - I can print these models on my Bambu Labs A1 without supports, even with sharp undercuts. Other printers might require support structures. - I now use, 4 top layer, 4 bottom layer, 2 sidewall, 10% sparse infill adaptive cubic. saves a ton of time and material. but might require the +.1 pins.