Laticrete StoneTech Semi Gloss Finishing Sealer Water-Based

StoneTech Semi-Gloss Water-Based Finishing Sealer Features The two-in-one formula leaves an alight sheen and protects against stains Easy-to-use, water-based formula Interior use Where to Use Slate, saltillo, limestone, travertine, and concrete floors Not intended for use on glazed, polished, or non-absorbing surfaces, wood floors, decks, showers, countertops, or near pool areas Directions for Use Read the entire label before using it. Use only as directed Always test in a small, inconspicuous area to determine the appropriate application method, achievement of desired results, and to ensure good adhesion Ensure the work area is well-ventilated during application and until the surface is dry Avoid applying in direct sunlight The surface must be thoroughly clean, dry, and free of any sealers or coatings before application Application to a dirty or dusty surface will affect adhesion and appearance High Gloss Finishing Sealer should not be applied to a wet or moist surface. Avoid applying onto surfaces not intended for treatment. The sealer can be used for new installations 48 to 72 hours after grouting. Fresh concrete slabs require a minimum of 28 days to cure before applying the sealer Liberally apply 2 to 4 even coats with a natural bristle brush, roller, or paint pad applicator Do not apply the product with a sprayer or sponge. Avoid puddling of liquid during application Failure to apply a sufficient amount of sealer to the surface may result in an undesirable finish or degradation of the coating More coats may be applied if desired Allow 30 to 45 minutes between coats or until the surface is dry to the touch Surface traffic may begin 12 hours after final application; keep installation dry for a minimum of 12 hours; complete cure is achieved in 24 to 48 hours Keep surface clean and dry as finished surfaces may become slippery when wet Available Sizes and Coverage Quart: 25-75 sq ft Gallon: 100-300 sq ft 5 Gallon: 500-1,500 sq ft