StoneTech Honing Powder 800 Grit Extra Fine

Laticrete Stone Tech Honing Powder 800 Grit Extra Fine Features Creates honed finishes Sets up the stone for polishing and shining Different grits eliminate mild to deep scratches Non-acidic Coverage (600 Grit, 800 Grit): 750-1,500 sq ft per pound Where to Use Natural stone such as marble, limestone, travertine and terrazzo Directions for Use Read the entire label before using it. Use only as directed Always test in a small, inconspicuous area to determine ease of application and desired results Allow new grout installations to cure for a minimum of 72 hours prior to application Make sure the surface is clean, dry, and free of waxes and coatings If the surface is heavily soiled, pre-clean with StoneTech Professional KlenzAll Cleaner if needed Mask any surfaces not intended to be treated. If you are using a variety of abrasive grits, ensure that the surface is well-rinsed and a new pad is used for each changeover Apply approximately 1/2 cup Honing Powder plus 1 cup clean water to the stone surface Refinish using a hand orbital sander or weighted floor machine at 130–140 lbs, 175 rpm, fitted with a natural hair pad. Keep the compound wet while refinishing with plenty of water Add Honing Powder as needed Refinish the area until the desired level of hone has been achieved Rinse well and use a wet vacuum or hot water extraction unit to remove all remaining compound Clean equipment with water Use successively higher grits of Honing Powder to close the face of the stone and follow with StoneTech Professional Polishing Powder and StoneTech Professional Shining Powder as applicable