Stick It Anchor Pins Motor Mount Bracket

Included: Aluminum motor mount bracket for starboard or port side in black or white Impact cushion Rubber grommet The Stick It Anchor Pins® Motor Mount Bracket is a ⅜” thick aluminum mounting bracket that attaches where your motor meets the transom. It mounts directly on top of your outboard motor’s mounting bracket.   It’s recommended for flats boats/bass boats up to 20ft and bay boats up to 19ft and with 200hp engines or less. Motor Mount will fit engine bolt spacing of 7-1/4” to 8-1/2” inches apart.   Be sure to check for clearance of trim tabs, trailer tie downs, eye cleats, poling platforms, or any other object mounted near your transom wall. It can be used with some jack plates, but when moving the jack plate, clearance can be an issue.    Installation is easy. Loosen the upper motor mount nut and place the Stick It Anchor Pins® Motor Mount onto it and hand tighten.  Then loosen the lower nut and slip the Motor Mount hole over that bolt.  Tighten both nuts and that's it! It’s just that easy.