Siser EasyPatterns Plus Glow 11.8" Roll (Pre-Masked)

EasyPatterns® Plus Glow Heat Transfer Vinyl It's EasyPatterns Plus that now glow in the dark! These pre-printed and pre-masked patterns will "charge" under light, and glow an eerie green in the dark! Just like other EasyPatterns Plus designs, EasyPatterns Plus Glow does not require a masking step. Simply cut designs mirrored carrier-side down just like any other HTV, weed away the excess material, and you're ready to apply! EasyPatterns Plus Glow is a great way to achieve glowing, patterned designs with just a single piece of HTV. However, it is not recommended to layer additional HTV on top, as EasyPatterns Plus Glow should be used as a top layer only. EasyPatterns are CPSIA Certified so you can decorate kids' items with confidence. Specifications: PU composition • Pressure sensitive backing • Semi-gloss finish • 100 Microns/3.9 Mils • 45°/60° blade CUTTER SETTINGS Siser Romeo & Juliet: Blade: 45°/60° Gram Force: 5-10 Offset: .250 Speed: 10 Cricut Explore Air: Blade: AutoBlade, Standard Setting: Iron-On Cricut Maker: Blade: AutoBlade, Fine-Point Setting: Heat Transfer, (Non-Cricut) Silhouette Cameo 4: Blade: Standard, 3 Material: Heat Transfer, Smooth Material: Smooth Speed: 8 Force: 6 Scan N Cut DX: Blade: AutoBlade, 3 Cut Speed: 5 Half Cut: Auto Roland GS/GX-24: Blade: 45° Gram Force: 80-90 Offset: .250 Speed: 25-50 cm/s Graphtec: Blade: 45° Gram Force: 9 Tool: CB09U+0 Speed: 25 cm/s Titan 2 & 3 Blade: 45°/60° Gram Force: 60-65 Speed: 300mm/s *Blade Advancing Varies Settings may vary based on blade condition and age of machine. Always perform a test cut prior to cutting designs. APPLICATION INSTRUCTIONS Application Instructions (home iron) • Mirror design and cut according to your cutter's settings • Set iron dial between Cotton and Linen • Cover with Heat Transfer Cover Sheet or Multipurpose Paper • Place on flat, hard surface (ironing board not recommended) • Press iron with medium/firm pressure (do not slide iron) for 15 seconds • If areas of design lift after application, replace cover sheet and re-press for 10 seconds • Peel carrier hot or cold Application Instructions (heat press) • Cut material - MIRROR! • Weed excess material • Cover with Heat Transfer Cover Sheet or Multipurpose Paper • Preheat garment for 2-3 seconds • Apply design at 305°F/150°C • Use medium pressure for 10-15 seconds • Peel carrier hot or cold RECOMMENDED ACCESSORIES & CARE EasyPatterns Applies to: 100% cotton Poly/cotton blends 100% polyester Leather Recommended Accessories: Siser Weeder Laundering: Wait 24 hours before 1st wash Machine wash cold / mild detergent Dry on normal dryer setting Do not dry clean Do not bleach