Silicone Glitter Bear Nose

Size: 2 1/4 inches wide x 1 7/8 inches tall. These will fit on our small K9 Blanks and our bear blanks. Simply cut out, and glue the backing down to shaved fur areas or directly to the resin blank. It's also best to tack it down in a few areas with a needle and thread, to make sure it stays put. All are made with a high quality squishy silicone and dyes. The color is dyed all the way through, so no worries on it rubbing off. Silicone Noses come automatically nose holes clear for better air ventilation, just need to trim away the backing where the nostrils are.The rest of the backing is kept in-tact, and you apply glue to it, to glue it down to your head. In the comment box, be sure to either type out a color, or give us a hex code. If you leave it blank, we will simply match the silicone color to the color of the glitter chosen. If you choose the 2 or more color option, type out what colors and the pattern you want them in inside the box. (example: Pink w/pink glitter front black w/green glitter back, or Pink w/blue glitter with black w/pink glitter dapple, green w/green glitter with blue w/blue glitter spots, etc)(Currently not available) Glitter Colors to choose from: Aqua, Black, Blue, Copper, Dark Blue, Dark Green, Dark Pink, Dark Purple, Gold, Gold Rush, Green, Glow in the Dark, Iridescent, Light Blue, Light Green, Light Pink, Light Purple, Orange, Pink, Red, Tiger's Eye, Silver, Silver Ghost, Yellow These are dyed and have lots of glitter in them. There is a layer of glitter on the surface that may wear down over time, however there is also glitter mixed into the silicone itself. *Facts about silicone that are good to keep in mind!* Silicone items cannot be painted, unless you have a silicone specific paint. Silicone cannot be glued to unless you have a silicone specific glue, so you have to leave the fabric backing on or sew it down. Silicone tends to be grippy, so it will collect dust, dirt and fur. In order to keep this from happening, just dust it with a light layer of baby powder before you install and you should be OK. In order to clean silicone from the debris it has picked up you can either use a piece of tape or other sticky surface (lint brush etc) to grab it all. Then apply your baby powder to keep it from happening in the future.