SAE J2716 (SENT) – USB Interface

The SENT-USB is a two-channel SAE J2716 (Single Edge Nibble Transmission – SENT) to USB interface that easily connects a SENT bus to any computer with an USB port. The converter is powered from USB and features two bi-directional SENT channels and an USB virtual COM port. The device comes with a free-of-charge PC application for SENT communication analysis and simulation. An open communication protocol over the virtual serial port enables the user to integrate the interface into an existing system. Features Tech Specs Documents Downloads SENT to USB Interface SENT logger/tester/simulator Two independent SAE J2716 (SENT) channels Each channel configurable as RX or TX, USB-powered USB Interface (Virtual COM port) Supports Fast and Slow Messages according to SAE J2716:2016 (Fast, Short Serial, and Enhanced Serial) Supports SENT/SPC Configurable SENT channel parameters – Tick Time, Nibble Count Included PC application Additional Features: On-board remanent memory Intelligent message filtration 4x LED (3x Status, 1x Power) 1x Reset switch 5V DC output with over-current protection 1x 8-pin terminal block, 1x Micro-USB Table or DIN-rail mount Hardware and firmware customization on request SENT-USB Interface Data Sheet SAE J2716 (SENT) – USB Interface Data Sheet