RTS Let them Spangle

SPANGLE TRANSFERS ARE HERE! Adult - 11 inches wide Set the heat-press to 280 degrees Fahrenheit.  Set the timer to 12 seconds.  Place a Nomex heat pad on the bottom platform of your heat-press.  Adjust the upper platform so the pressure is high, but still able to lock down.  Pre-press your garment to flatten out any wrinkles, then allow it to cool a little bit.  Cut away any excess transfer paper that serves no purpose. Place spangle design, no need for a nonstick cover sheet or an internal nonstick sheet.  Lower heat-press.  Once finished, remove garment and lay out flat, design downward, on your work table.  Rub the backside of the design to assist in cooling.  Turn it over and rub design firmly with another garment or even the sleeve of this one.  Once design is cool, peel off transfer paper in whichever motion works best for that design. Press a second time for half the original time frame. This helps to lock down the spangles. If any spangles come off during this peel, you can cut out the transfer paper that holds the spangle dot(s) and replace it where it belongs. Your cut out does not have to be too precise as to hold just the one little dot(s), it should be of a workable size. Reheat the whole design for just 5-6 seconds. Press the dot(s) firmly. Be careful not to move any of the others spangles since they will be vulnerable to movement. Allow the ‘dot’ to cool then carefully peel off the transfer paper cut out. This second pressing will serve as the second press for the whole design.  Washing / Drying instructions >>> - As with most decorated garments, care should be taken when laundering. - Turn the garment inside-out, if possible. - Do not launder with rough items within the same washer. - Use ‘Gentle Cycle’. Water temperature should be Cold or Warm, but not Hot. - Drying is your choice: Hang to dry, or use Low Heat settings.