Rolled Front Springs

I have wanted to get my Rolled Springs on my website for sometime now, Here they are. I have 7 sizes to choose from. From the shortest liner spring to the longest shader spring and every size in between. they come in .020 thickness. Please pick your springs carefully. The bottom line is, you can't order any random spring for your machine and expect it to work, drastically changing the angle of your contact screw is no way to compensate for this. FRONT SPRINGS WITH A SLOT FOR ADJUSTMENT, SUCK. Where the spring sits on the A-bar should be a closed hole,(front and back springs) not a slot. Take the time to figure out what you need and order right the first time. I will show the measurements in decimal and standard inch units below for you to order. The center of the hole is .220" from the rear. The springs are ROLLED and ready to go on your machine. Install the front spring, push it down to your A-bar and the angle is set, adjust the tension in your rear spring and you're done. These springs help your machine run smoother and stay in tune longer. The three short ones are good for liners and the four long ones are good for shaders. A good way to get the length you need is to install your rear spring and put your contact where you want it. Measure from the center of the screw the the front side of the contact screw and add .220 to the measurement.