1-1/8" x 12" Straight Shank Rebar Cutter

A carbide-toothed rebar cutter for when your hole runs into steel. Chuck it in a drill with a 1/2" chuck, run it in rotation only, and it cuts through the rebar so the concrete bit can finish the hole. It is a problem solver, not a concrete bit: never use it to drill concrete. Expect a limited life: by ITM's own figures, a 1/2" cutter that meets #6 (3/4") rebar dead center may drill 5 to 10 holes at the correct speed and pressure, and it is not unusual for a cutter to cut only one bar. Rebar cutters are not warrantied for replacement or repair. Cutting a lot of rebar? ITM's 1-1/8" SDS-Plus Rebar Puncher runs in rotary hammer mode, cuts about twice as fast, and is best on #5 (5/8") rebar and under. Specifications: Size: 1-1/8" Overall Length: 12" Shank: Straight, for a 1/2" drill chuck Speed: 500-750 RPM Mode: Rotation only, no hammer Construction: One-piece Features: Tungsten carbide cutting teeth Cuts rebar hit while drilling reinforced concrete Rotation only Sold individually, one per tube For use in: Rebar Reinforced Concrete (cutting the bar, not the concrete)