RapidAir FastPipe Spanner Wrench - Sold Individually (Various Sizes) - 2 Required

The RapidAir FastPipe spanner wrench is for use with the FastPipe compressed air system.  Two spanner wrenches are required to tighten the FastPipe fittings when installing the FastPipe blue rigid aluminum air pipe system.  Please note that you will need to purchase the correct sized spanner wrench for the size FastPipe you are installing and two wrenches are required for proper FastPipe installation (spanner wrenches are sold individually).    Specifications: RapidAir FastPipe spanner wrench sizes (wrench size based on size of FastPipe you are installing):  ¾”, 1”, 1 ½”, 2” & 3”   Spanner wrenches are sold individually (2 are required for installation)   FastPipe Installation Steps: CUT PIPE TO LENGTH with tubbing cutter (cut must be square)           (DO NOT USE HACK SAW)   DEBURR the end of the pipe outside and inside           (a smooth edge allows easy fitting assembly and no damage to the fitting o-ring)   MARK END OF PIPE for the proper insertion depth ¾” Fittings: 2 inches 1” Fittings: 2 ¾ inches 1 ½” Fittings: 4 inches 2” Fittings: 4 ¾ inches 3” Fittings: 4 ½ inches   WET END OF PIPE, with very diluted soapy water          (DO NOT USE ANY OIL OR GREASE LUBRICANT)   LOOSEN fitting cone nut partially          LOOK INSIDE EACH FITTING FOR INNER PARTS          (inner parts, o-ring, stainless steel bite ring)   INSERT PIPE into fitting until pipe bottoms out          HAND TIGHTEN fitting          FULLY TIGHTEN fitting with FastPipe spanner wrenches     *(Please note that two spanner wrenches are required for proper FastPipe installation.  The spanner wrench can also be purchased as part of the installation tool kit based on the size of FastPipe that you are installing.  In addition, the Pipe Selection Guide and Quote Form can be found below).