Rail Caps - 2-3 Drawer Packout Rails

Struggling to remove the rails from the Packout drawers? Look no further than the Packible tool Rail Caps.  These caps replace the ones that come with the drawers that have the dreaded tab that requires far too much forceful prying to remove, often damaging the box.  Take them out once, replace them with the Packible Tool Rail Caps and removing them in the future is as easy as removing a single 1/4-20 bolt.  This means doing future mods or upgrading/adding new rail mounted accessories just got that much easier.  3D Printed out of ultra tough & heat resistant ABS plastic. Threads are roll form tapped for extra strength.  1 Kit is enough to do one Packout drawer box. Kit Includes:  4X Rail Caps 4x 1/4-20 Stainless Steel Bolts You will need to reuse the screws that fasten the old cap on the new one. So do not discard.    ***IF YOU ATTEMPT THIS MODIFICATION YOU DO SO AT YOUR OWN RISK, THERE IS A CHANCE YOU CAN DAMAGE YOUR BOX WHILE ATTEMPTING IF NOT DONE PROPERLY. MAKE SURE PLASTIC IS WARM & TAKE YOUR TIME. IF PLASTIC IS COLD, IT WILL BE BRITTLE AND INCREASE RISK OF DAMAGE TO BOX.***