Radius End Full Rack Assembly w/ DTRs

This Is A Complete Radius End Full Rack Assembly With All Required Hardware &  Double Tap Rails. This Rack Systems End Assembly Has A Radius Side Profile That Drops The Bottom Of The Rack 2.25" (5.71 cm) To Match A Roofline Of A Vehicle Or To Offer A Unique Look Compared To Its Flat Counterpart. This Rack System Comes Powdercoated In A Fine Textured Black - For This Assembly In A RAW Finish*, Click HERE . The Overall Rack Length & Width Will Be Determined Through The Choices Above. Each Full Rack Assembly Contains The Following: (2) Radius Ends (Driver & Passenger Sides) (2) Radius Upper Tubes (Driver & Passenger Sides) (2) Short Ends (Driver & Passenger Sides) (2) Short Upper Tubes (Determined By Length) Intermediate Assemblies (DBL) Double Tap Side Supports & Hardware (DBL) Connector Slugs (DBL) Connector Slug 316 Stainless Hardware Sets  (DBL) Threaded Slugs (DBL) Threaded Slug 316 Stainless Hardware Sets (DBL) Crossbars (Of Selected Width) (DBL) Standard Hinge Or Rain Gutter Mounts (Selection Confirmed After Order Is Placed) Optional Selections LENGTH Choose Overall Rack Length Measurement (Outside Of Rack Tube To Outside Of Tube, With This Configuration The Useable Basket Area Would Be 8" (20.32cm) Shorter Than The Overall Rack Length) WIDTH Choose Overall Rack Width Measurement (Outside Of Rack Tube To Outside Of Tube, With This Configuration The Useable Basket Area Would Be 2" (5.08cm) Shorter Than The Overall Rack Width) AIRDAM ASSEMBLY Yes - Add Airdam: Includes The Recommended Removable Airdam Assembly Which Is Used At The Front Of A Cargo Rack System To Deflect Air Over The Rack To Reduce Wind Noise [Note This Airdam Assembly Is Designed For Use With A System Running Double Tap Rails Only]  No - Do Not Add AirDam: Airdam Assembly Is Not Included But Can Be Purchased And Added At Any Time. REMINDER: Each Full Rack Assembly Requires A Mounting Selection After The Rack Is Purchased, Standard Hinge / Rain Gutter Mounts Are Included In This Assembly, HD Mount Upgrades Are Available And Can Be Selected Below. *Corrosion Resistance Is Only Achieved Through A Post Applied Finish On The Raw Aluminum Components (I.E - Powdercoat Or Anodizing). Raw Finish Will Not Provide ANY Corrosion Resistance And MUST Be Coated Before Installation.