Radius End Assembly w/ HDRs + Airdam

This Is A Complete Radius End Assembly With All Required Hardware, Hybrid Death Rails And An Airdam Assembly. This Single End Assembly Has A Radius Side Profile That Drops The Bottom Of The Rack 2.25" (5.71 cm) To Match A Roofline Of A Vehicle Or To Offer A Unique Look Compared To Its Flat Counterpart. This End Has The Removable Airdam Assembly Which Is  Used At The Front Of A Cargo Rack System To Deflect Air Over The Rack To Reduce Wind Noise. The Overall Length Of The Rack System Will Be Increased By 15" (38.10 cm) And Comes With The Necessary Hardware To Bolt Into Your Existing Setup.  Each Assembly Contains The Following: (2) Radius Ends (Driver & Passenger Sides) (2) Radius Hybrid Death Rails Sets (2) Hybrid Death Rail Radius Kick Connectors (Driver & Passenger Sides) (4) Hybrid Death Rail 316 Stainless Hardware Sets (2) Hinge Mount Standard Assemblies (W/ Mounting Hardware Selected Above Unless No Mounts Or Hardware Option Selected) (2) Connector Slug 316 Stainless Hardware Sets  (6) Threaded Slugs (6) Threaded Slug 316 Stainless Hardware Sets (3) Crossbars Of Selected Length (1) Airdam Assembly (Airdam & Mounting Hardware) Of Selected Length Optional Selections MOUNTING STYLE    Track Mount - These Zinc Coated Track Nuts Are For Use With YAKIMA® or Equivalent Extruded Aluminum Track Systems  Hard Mount (Exp) - This Mounting Style Uses Drilled Holes And Expansion Nuts To Affix The Mount To The Mounting Surface Hard Mount (Riv) - This Mounting Style Uses Drilled Holes And RivNuts To Affix The Mount To The Mounting Surface - RivNuts Require A RivNut Tool To Install Which Can Be Purchased HERE No Hardware - No Mounting Hardware Is Included (Holes Are Designed For M6 or 1/4" Size Hardware)  No Mounts Or Hardware - No Mounts Or Mounting Hardware Is Included FINISH Textured Black - A Durable Fine Textured Black Powdercoat Finish Raw - Raw Aluminum Finish With No Surface Prep* WIDTH Choose Overall Rack Width Measurement - These Are Not The Measurement Of The Crossbars Themselves, But Using The Selected Crossbar Sets The Overall Rack Width - Custom Widths Are Available By Contacting Our Sales Team At Info@Zombieracks.com  *Corrosion Resistance Is Only Achieved Through A Post Applied Finish On The Raw Aluminum Components (I.E - Powdercoat Or Anodizing). Raw Finish Will Not Provide ANY Corrosion Resistance And MUST Be Coated Before Installation.