Radius End Assembly w/ DTRs

This Is A Complete Radius End Assembly With All Required Hardware & Double Tap Rails . This Single End Assembly Has A Radius Side Profile That Drops The Bottom Of The Rack 2.25" (5.71 cm) To Match A Roofline Of A Vehicle Or To Offer A Unique Look Compared To Its Flat Counterpart. The Top Rail Of This Assembly Sits 2.75" (6.98cm) Shorter In Length Than Its Lower Welded Assembly. The Overall Rack Length Will Be Increased By 15" (38.10 cm) And Comes With The Necessary Hardware To Bolt Into Your Existing Setup. This Assembly Can Be Used With Any Height Side Supports (Not Included). Each Assembly Contains The Following: (2) Radius Ends (Driver & Passenger Sides) (2) Radius Upper Tubes (Driver & Passenger Sides) (2) Hinge Mount Standard Assemblies (W/ Mounting Hardware Selected Above) (4) Connector Slug 316 Stainless Hardware Sets  (8) Threaded Slugs (8) Threaded Slug 316 Stainless Hardware Sets (4) Crossbars Of Selected Length Optional Selections MOUNTING STYLE    Track Mount - These Zinc Coated Track Nuts Are For Use With YAKIMA® or Equivalent Extruded Aluminum Track Systems  Hard Mount (Exp) - This Mounting Style Uses Drilled Holes And Expansion Nuts To Affix The Mount To The Mounting Surface Hard Mount (Riv) - This Mounting Style Uses Drilled Holes And RivNuts To Affix The Mount To The Mounting Surface - RivNuts Require A RivNut Tool To Install Which Can Be Purchased HERE No Hardware - No Mounting Hardware Is Included (Holes Are Designed For M6 or 1/4" Size Hardware)  No Mounts Or Hardware - No Mounts Or Mounting Hardware Is Included FINISH Textured Black - A Durable Fine Textured Black Powdercoat Finish Raw - Raw Aluminum Finish With No Surface Prep* WIDTH Choose Overall Rack Width Measurement - These Are Not The Measurement Of The Crossbars Themselves, But Using The Selected Crossbar Sets The Overall Rack Width - Custom Widths Are Available By Contacting Our Sales Team At Info@Zombieracks.com  *Corrosion Resistance Is Only Achieved Through A Post Applied Finish On The Raw Aluminum Components (I.E - Powdercoat Or Anodizing). Raw Finish Will Not Provide ANY Corrosion Resistance And MUST Be Coated Before Installation.