RAD PiZ2W 3D Printed Case for Commodore

This is a case for your RAD Expansion Unit/Raspberry Pi Zero 2W combo cartridge. As a COREi64 original design, you can expect a robust case with smooth exterior surfaces.  The case uses brass heat sets and screws to keep it closed, allowing easy opening and closing as often as you wish without worrying about wearing out the fastener location of the case.  All raspberry pi board edge ports are accessible through the case, including easy access to the SDcard. The RAD Expansion cartridge is an open source "build it yourself" or "get a buddy to build it for you" project.  The source files can be found on the developers github page found here. (RAD Expansion Github). Because this is a "build it yourself" board, I cannot be held responsible for incorrectly soldered components due to the BOM on the github being rather lacking in the specific components needed (ie: manufacturer part numbers).  Note that this is for the cartridge case only.  Any other hardware shown in the photos is for illustrative purposes only. This case requires a 1.5mm allen wrench.  If you have any questions, reach out.