ProTeam® ProForce®, Progen® & Super HalfVac® HEPA Filter

This HEPA filter fits the ProTeam ProForce 1200XP, 1500 (now discontinued), 1500XP models, as well both the Progen 12 & 15, as well as the discontinued Super HalfVac. It is an integral part of the recovery process, as it captures 99.97% of dust as small as 0.3 microns. It is the final defense, and captures the smallest particulate that has passed through the intake filter and the motor, before it is exhausted back into the air. To access the HEPA filter on the ProTeam Super HalfVac, you will need to undo the velcro strap on the top of the vacuum connected to the backplate. Depress the tabs on top of the vacuum unit to open and remove filter housing from vacuum. Then remove the HEPA cartridges by pulling on the filter tab. Once the filters are replaced, slide bottom of filter housing in position and click the top into place. Re-attach velcro strap on top of vacuum. Not only does this filter fit the Super Halfvac, but it also fits the ProForce and ProGen models that we also offer. To change it out on these models, simply depress the side release latch and remove the filter cover. Remove old HEPA filter, clean out the cover grating and any other dirt in the vac chamber, then place a new filter into the cover. Replace cover. *Warning: Do not reuse HEPA filters, as this can eliminate the efficiency of the recovery of the vacuum. We also have micro filter Super HalfVac bags and ProTeam ProForce bags available if you are need of those as well to keep your ProTeam vacuum performing at its optimum level.