Pro Tect Water Resistant Hardboard Seam Tape

Pro-Tect® — Construction Tapes WR Hardboard Seam Tape Contractor-grade adhesive seam tape — 3" × 60 yards. Tested and proven to be the best tape for seaming Pro-Tect® WR Hardboard panels together on job sites. Designed specifically for use with Pro-Tect® WR Hardboard floor protection. This seam tape holds panels securely together across large areas, prevents shifting, and maintains the water-resistant seal between boards — critical when protecting floors during construction, renovation, or heavy-traffic jobs. Key Benefits Tested for WR Hardboard Specifically tested and chosen by Pro-Tect as the best tape for seaming WR Hardboard panels — not a generic tape. Contractor-grade adhesive Strong, reliable hold that keeps panels from shifting under heavy foot traffic, tools, and equipment. 3" wide coverage Wide 3" width spans seams generously — provides a full, secure bond across the joint. 60 yards per roll 180 linear feet per roll — enough to seam large areas without having to stop and change rolls mid-job. Maintains water resistance Seals the joint between WR Hardboard panels to preserve the 72-hour water resistance of the system. Speeds up installation Works with WR Hardboard's fast-lay system — cover large areas quickly with consistent seam quality. Applications Seaming WR Hardboard panels Large-area floor protection Construction & renovation sites High-traffic job site corridors Hardwood & tile floor protection Concrete & marble surface protection How to Use Step Process 1 Lay out Pro-Tect® WR Hardboard panels across the floor surface, butting edges together tightly at the seams. 2 Center the Seam Tape over the joint between two panels. 3 Press the tape firmly down across the full length of the seam — work from one end to the other to avoid air bubbles. 4 Run your hand or a roller along the tape to ensure full adhesion across the entire width. 5 Continue taping all seams until the full floor area is covered and secured. Technical Data Property Details Width 3 inches Length 60 yards (180 linear feet) Quantity 1 roll Adhesive type Contractor-grade pressure-sensitive Designed for Pro-Tect® WR Hardboard (20 mil & 44 mil) Purpose Panel seaming — holds boards together, maintains water resistance Compatible surface WR Hardboard — any hard floor surface underneath Downloads Technical Data Sheet — WR Hardboard & Seam Tape System PDF — official Pro-Tect product specifications This tape is designed to be used with Pro-Tect® WR Hardboard floor protection. When covering large areas, lay boards end-to-end and side-to-side, then tape all seams for a continuous, secure surface. One roll covers approximately 180 linear feet of seams.