Pre-Wired Monkey Bars

🗦PRE-WIRED🗧 MONKEY BAGGER BARS For all 2014-Present (Rushmore) Batwing Fairing Models For all 2015-Present (Rushmore) Road Glide® & Road Glide® 3 Models (1¼” Handlebar with a 1” clamp & grip area or 1¼” Handlebar with a 1¼” clamp and 1" grip area) Original MBB Monkey Bars 101: Width: Our bars are several inches narrower than others because we utilize a more labor-intensive process of rosette welding the grip post areas. Swedging is cheaper, but it adds over 2” of width to each side of the bar! A critical comfort detail! Natural Grip Angle: Our bars were painstakingly engineered to provide a natural, relaxed grip angle. They don’t force your hand or wrists into an uncomfortable position. Non-riders would never think of this. Adjustability: Our bars are designed to allow maximum rotation regarding your hand control position. Everyone has a different taste and comfort zone here, so it’s important to be able to put em’ where you want em’! Pull Back: Our bars are specifically designed to provide excellent pullback. 9″ if so desired, for optimum back and neck comfort. Ease of Installation: Our bars are engineered to be a direct bolt-on replacement bar! Now if the thought of installing your new Original Monkey Bars has you stressed out, relax…WE GOT THIS SH!T WIRED! Pre-Wired Monkey Bars come complete with internal switch wires and connectors installed. We have also installed pull wires which allow for easy Twist Grip Throttle Sensor exchange as well as installing heated grips Original Monkey Bars are R.D.R.S. Compatible! LEARN MORE ABOUT THE ORIGINAL MONKEY BAR! 2014/2020 When changing stock bars to our 8″ & 10″ PRE-WIRED Monkey Bagger Bars, you DO NOT NEED new lines. On 12″, 14″, or 16″ Monkey Bagger Bars, you NEED clutch & brake line replacements. NEW 2021/Present When changing stock bars to our 8″ Monkey Bagger Bars, you DO NOT NEED new lines. On 10”, 12″, 14″, or 16″ Monkey Bagger Bars, you NEED clutch cable & brake line replacements. NOTE to CVO & Road Glide Ultra owners: A standard Road Glide® master cylinder half clamp is required when installing 2015 and later OEM Monkey Bars on CVO models. The part numbers for the H-D clamps are as follows... CHROME 36700114: Left side half clamp (chrome) 41700325: Right side half clamp (chrome) BLACK 36700113: Left side half clamp (satin black) 41700321: Right side half clamp(satin black) NOTE to Road Glide 3 owners: A replacement set of handlebar half clamps is required when installing OEM Monkey Bars on the NEW Road Glide® 3. The part numbers for the H-D clamps are as follows... 36700246: Left side half clamp (satin black) 41700948: Right side half clamp(satin black) NOTE: Bagger Nation STRONGLY recommends installing our 1-piece Super Riser Clamp on ANY handlebar install! Failure to use a one-piece clamp when installing Monkey Bars will VOID the Bagger Nation warranty. WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, visit www.P65Warnings.ca.gov Prices are subject to change.