PolySeal Water-Based Polyurethane Acrylic Interior Wood Varnish

margin-left: 0; } /* see gallery_shortcode() in wp-includes/media.php */ PolySeal Interior Wood Varnish for Beautiful Wall, Woodwork, and Floor Protection Seals the wood pores and helps maintain an allergy free environment Cleaning and dusting are more thorough and effective Adds depth and clarity to the wood grain Scrub and mar resistant Low fumes User Friendly – Easy to apply Less drips means less mess Dries Fast – Apply up to 3 Coats in a day Can be used on Hardwood floors Soap and water cleanup   Coverage Coverage will vary according to the porosity of the wood, method of application, and application techniques. Use these coverage guidelines. 1st Coat 250 SF per Gallon per Coat 2nd Coat 300 SF per Gallon per Coat 3rd Coat 400 SF per Gallon per Coat   PolySeal Interior Wood Varnish Colors Crystal Gloss Crystal Satin Amber Satin Light Timber Amish Pine Maple Satin Shelf Life The Shelf Life for PolySeal Interior Wood Finish is 2 Years from date of purchase. Wood Moisture Content Do not apply PolySeal to wood surfaces that have a moisture content of greater than 18%. Applying PolySeal to green wood or other wet surfaces can cause discoloration of the PolySeal as well as other coating problems.   Surface Preparation For best results the wood surface where PolySeal Interior Wood Varnish is to be applied must be clean, dry, and free from dust, grease, oil, wax, dirt, paint, and fungus. If necessary, before coating with PolySeal fill any holes or checks will a good quality acrylic or latex based wood filler. Do not use wax sticks or wood fillers that contain waxes or separate additives. Previously varnished surfaces that are in sound condition should be sanded and cleaned before applying PolySeal. Do not apply PolySeal to wood surfaces that are cold or damp. Do not apply PolySeal to wood with a moisture content that exceeds 18%.   Mixing Mix PolySeal Interior Wood Varnish thoroughly before applying. Use a drill mixer until product is completely blended. Do not shake the product or otherwise create foam. Do not dilute PolySeal.   Application Temperatures The ideal application temperature for PolySeal Interior Wood Finish is between 65 – 80 °F. If application temperatures are significantly colder or hotter, PolySeal may not apply in a smooth and fluid manner resulting in an uneven application and appearance. Application in high humidity will extend the dry time and at times can interfere with the ability of PolySeal to spread evenly and form a good film.   Application Methods Apply PolySeal Interior Wood Finish with a good quality synthetic bristle varnish Brush or a pad applicator. Apply in even strokes and avoid excessive brushing. Do not apply this product with an airless sprayer. Because PolySeal dries fast, care must be taken to avoid lap marks. Apply PolySeal at a steady even tempo and always coat the piece of wood to completion, don’t stop in the middle. When reloading the applicator begin the new application 4-6 inches in advance of where you stopped and work back to the stopping point and then proceed forward in order to reduce the likelihood of lap marks.   Clean-Up After applying PolySeal clean brushes, tools and equipment immediately with warm soapy water and then rinse clean with fresh warm water.   Dry to Touch PolySeal will be dry to the touch within 60 to 90 minutes after application, assuming it was applied at 70 °F and in moderate humidity. Please note that a milky haze can occur if a second coat is applied too quickly without allowing the previous coat to properly dry.   Maintenance Keep PolySeal coated wood surfaces dusted and clean. To clean dirtier stained areas use Murphy’s Oil Soap or similar wood cleaners. Do not clean PolySeal coated wood surfaces with cleaners that contain alcohol or strong cleaning agents.     Click here for this product’s Safety Data Sheets (SDS)