Perun MOSFET for Tokyo Marui Spec P90 Series AEG Gearboxes

Features Ultra compact MOSFET designed for P90 gearboxes Adjustable trigger sensitivity with 5 adjustable levels Programmable firing modes Active Braking for perfect shot management Pre-cocking function for improved trigger response Binary trigger for faster semi-auto rate of fire Rate of fire reduction mode for increased realism Low battery voltage alarm helps protect your lithium battery packs Detection mode prepared to work with dual sector gears Built-in diagnostic system helps monitor the rifle and MOSFET for easier troubleshooting Electronic fuse cuts off the battery circuit in case of malfunction, protecting the MOSFET and your rifle Perun for P90 replaces trigger bar and mechanical contacts in your P90 replica and provides lots of useful features. Magnetic sensors coupled with a magnet installed directly on the trigger, allow to remove the bar that connects trigger with the gearbox, making trigger pull much smoother. Proprietary cut-off lever (comes with the MOSFET) works with an optical sensor to eliminate all problems with single fire function. Selectable firing modes User can choose firing modes available after short or long pull of the trigger: SEMI ONLY, BINARY, SEMI-AUTO, SEMI-BURST, BURST-AUTO. Adjustable trigger sensitivity The trigger can be set to 5 sensitivity levels for both first and second trigger stage, ranging from short pull needed to fire a shot, to a long one. No modification to the trigger or the gearbox is needed and the trigger sensitivity change is possible even in the field. Active brake Active brake stops the motor after each shot preventing spring compression or in case of replicas with high rate of fire, overspin (double shot problem). Pre-Cocking Fast trigger response can be a matter of victory or defeat, especially in CQB situations. With pre-cocking enabled, piston will remain in rear position after each shot with the spring already compressed, ensuring that next shot will be fired immediately after you pull the trigger. To release the spring after using pre-cocking, pull the trigger and hold it for 2 seconds, after which a second shot will be fired, this time with no pre-cocking and fully braked. Binary trigger Allows for easy double shots in semi-automatic setting. After enabling this mode, if semi-automatic fire is set, shots will be fired not only when the trigger is pulled, but also when it is released. Rate of fire reduction Reduce the rate of fire in automatic or burst fire to save ammo or make the replica shoot in a more realistic fashion. Low battery voltage alarm Dedicated for Li-Po and Li-Ion batteries. Should the battery voltage fall to a dangerously low level, user will be notified by short sound signals that are repeated every minute. This may also be freely switched on and off. DSG A sector gear detection mode specially prepared to work with dual sector gears. Diagnostic system Constantly monitors the replica and the MOSFET itself. In case of any problems, immediately lets you know what it might be, making troubleshooting much easier. Electronic fuse Will save your replica and battery in case of a major malfunction. It will automatically disconnect the battery when a short circuit or blocked motor is detected. Programming of all the settings is done solely by using a button and multicolor LED diode mounted in the battery compartment and the trigger. That allows changing the settings in any moment, in a matter of seconds, even under enemy fire. All settings are set independently for each selector position, so you can program the MOSFET exactly the way you want, for example semi on semi and binary trigger on auto. Perun for P90 works without problems with any battery from, 7 V to 17 V. It can also be used with most extreme setups. Manufacturer: Perun Airsoft Specifications: Permissible Battery Voltage: 7V to 17V Compatibility: For use with Tokyo Marui, ACM, Asia Tactical, Classic Army, Cybergun, CYMA, Double Bell, J Tactical, JG and other compatible P90 AEG rifles Wiring: Universal-wired