PCAN-Repeater DR

Creates a connection between two high-speed CAN busses with galvanic isolation The PCAN-Repeater made by PEAK System Technik creates a connection between two high-speed CAN busses with galvanic isolation of up to 5 kV. Each CAN channel is decoupled from the other and from the power supply. CAN messages are forwarded 1:1 between the two channels and may be forwarded uni-directionally if required. The current bus status is displayed by means of LEDs. With its extended temperature range support and DIN rail housing.  Features Tech Specs Documents Downloads Two High-speed CAN channels (ISO 11898-2) Galvanic isolation rated up to 5 kV according to IEC60601-1, between both CAN channels and between CAN and power supply Bit rates up to 1 Mbit/s NXP PCA82C251 CAN transceiver LEDs display CAN bus load and CAN errors Each CAN channel can be selectively terminated Listen-only mode for CAN channel 1 or CAN channel 2 can be switched selectively Plastic casing (width: 22.5 mm) for mounting on a DIN rail 3 mating connectors for power supply and CAN connections Extended operating temperature ranges from -40 to 85°C (-40 to 185°F) *Please note: Due to the CAN protocol, the maximum length of a CAN bus depends on the bit rate. Therefore, a bus cannot be extended with the PCAN-Repeater. The physical total length of the CAN bus is reduced with each built-in PCAN-Repeater according to its signal delay. Indicators (LED) Status, Bus Load Baud Rate Up to 1 Mbp/s Certifications ISO 11898-2 Enclosure Plastic DIN rail Transceiver CAN: NXP PCA82C251 Isolation 5kV Isolation Operating Temperature -40°C to +85°C PCAN-Repeater manual User Manual in PDF format (English)