PCAN-Repeater FD

The PCAN-Repeater made by PEAK System Technik creates a connection between two high-speed CAN busses with galvanic isolation of up to 5 kV. Each CAN channel is decoupled from the other and from the power supply. CAN messages are forwarded 1:1 between the two channels and may be forwarded uni-directionally if required. The current bus status is displayed by means of LEDs. With its extended temperature range support and DIN rail housing, this CAN Repeater is suitable for use in an industrial environment. Features Tech Specs Documents Downloads Two High-speed CAN channels (ISO 11898-2) Galvanic isolation rated up to 5 kV according to IEC60601-1, between both CAN channels and between CAN and power supply Bit rates up to 1 Mbit/s NXP PCA82C251 CAN transceiver LEDs display CAN bus load and CAN errors Each CAN channel can be selectively terminated Listen-only mode for CAN channel 1 or CAN channel 2 can be switched selectively Plastic casing (width: 22.5 mm) for mounting on a DIN rail 3 mating connectors for power supply and CAN connections Extended operating temperature range from -40 to 85°C (-40 to 185°F) Please note Due to the CAN protocol, the maximum length of a CAN bus depends on the bit rate. Therefore, a bus cannot be extended with the PCAN-Repeater. The physical total length of the CAN bus is reduced with each built-in PCAN-Repeater according to its signal delay. Indicators (LED) Status, Bus Load Baud Rate Up to 1 Mbp/s Certifications ISO 11898-2 Enclosure Plastic DIN rail Transceiver CAN: NXP PCA82C251 Isolation 5kV Isolation Operating Temperature -40°C to +85°C PCAN-Repeater manual User Manual in PDF format (English)