PCAN-LWL

Coupling for optical transmission of CAN and CAN FD data For use in explosion-proof areas or for EMI/EMC measurements, the PCAN-LWL can be used to replace a stretch of CAN network with a fiber-optic line at any point. There are the options of conversion to high-speed CAN or low-speed CAN. The modules are supplied with power externally. PCAN-LWL CAN wire to fiber-optic converters, incl. 5 meter fiber-optic cable. (IPEH-002026-10m provides an optional 10 meter cable.) Features Tech Specs Documents Downloads LED display for transceiver status High-speed CAN: AMIS 30660 transceiver, max. 500 kbit/s, integrated 120 Ohm bus termination can be turned on/off Low-speed CAN: TJA1054 transceiver, max. 125 kbit/s, integrated 510 Ohm / 5.6 kOhm bus termination can be turned on/off, bus error display Fiber-optic line consists of a 62.5/125 µm fiber-optic duplex line with ST connectors Aluminum casing CAN bus connection via D-Sub, 9-pin (in accordance with CiA® 102) Supply voltage: 6.5 – 30 V Supply via D-Sub 9 pin, or DC connector (jumper) Operating temperature range from 0 to 70 °C (32 to 158 °F) High-speed CAN: D-Sub plug, 9 pins, in accordance with CiA® 102 Transceiver: AMIS 30660 Bit rate: max. 500 kbit/s Bus termination: switchable 120 Ω Low-speed CAN: D-Sub plug, 9 pins; in accordance with CiA® 102 Transceiver: TJA1054 Bit rate: max. 125 kbit/s Bus termination: switchable 510 Ω / 5,6 kΩ Signal delay (through 2x PCAN-LWL + 5 m OWG) High-speed CAN: approx. 250 ns Low-speed CAN: approx. 1,5 μs Optical wave guide Optical fiber duplex line with ST connector Supply voltage 6,5 - 30 V Power Consumption max. 50 mA (at 9 V) Operating temperature 0 - 70 °C (32 - 158 °F) Storage temperature -40 - 100 °C (-40 – 212 °F) Relative humidity 15 - 90 %, not condensing EMC EN 55024:2003-10 EN 55022:2008-05 EC directive 2004/108/EG Ingress protection (DIN EN 60529) IP20 Size 60 x 35 x 80 mm (B x H x T) Weight 138 g PCAN-LWL manual Documentation in English