PBH Coyote Engine Control Pack for Swaps

Our PBH Gen 2 and Gen 3 Control Packs are made specifically for Coyote swap applications and are available for either the Mustang or F-150 engine firing order configuration. Gen 1 engines do not require a change in firing order so we only have manual or 6R80 automatic transmission options. The PBH control pack kit was designed to help put the Gen 2 6R80, Gen 3 10R80 automatic transmission or a manual transmission behind virtually any Coyote engine swapped build. Using a factory PCM with a custom flash we can control both engine and transmission in one module, no need for any secondary controllers that might have some limitations. In this pack you will receive the PCM, PBH body harness, both O2 sensors, gas pedal, fuse box, mass air meter, and detailed instructions. The included PBH body harness will give installers and builders the ability to not only use a wide selection of transmissions, but to use it to full factory potential. We also left wiring leads for anyone who would like to add select shift buttons (6R80/10R80 only), electric steering, and oil pressure sender. You also get trigger wires for fuel pump and cooling fans so the factory computer can control them as well. The fuse block is detachable to make wiring installation easier. For automatic transmission applications the PCM supplied in the kit is an Auto Mustang GT unit. This allows us to use the select shift option just like factory. The computer will come with a custom flash and will be configured for either Mustang or F-150 engine firing order to allow start up and custom tuning. For manual transmission applications the PCM supplied in the kit is a manual GT Mustang unit. The computer will come with a custom flash and will be configured for either Mustang or F-150 engine firing order to allow start up and custom tuning.