Offset Winch Snatch Ring

Order Quantity 1 = 1 Ring    For use with synthetic HMPE winch line ONLY WARNING: When performing a winch recovery, start with a single line pull (1:1), and work up to other configurations, ie 2:1 ---> 3:1, etc. The risk of overloading your tow/connection points increases with each additional configuration. Never exceed a 5:1 pull with this ring. A 4:1 pull should ONLY be done by professionals, using 2 winch rings, a safety catch sling, and double loop 7/16" soft shackles are required. In these configurations, it is easy to exceed the rating of some tow/connection points, you MUST KNOW those ratings before use. These are NOT designed for heavy-duty wrecker use. Use ONLY electric bumper-mounted winches rated at 12k lb or less. NEVER use Steel Cable with this ring, Only use a Synthetic (HMPE) winch line no larger than 7/16" diameter. Not for over-head use. Description The Offset Winch Snatch Ring is a machined aluminum winching block designed for synthetic HMPE winch line up to 7/16" diameter. Two rings and three soft shackles do the job of four standard snatch blocks and five hard shackles at a fraction of the weight and zero bearing maintenance. Built for electric bumper-mounted winches rated 12,000 lbs or less. The offset design solves a real problem: on a 2:1 setup, you run the winch line through the hole instead of the groove, which means the line physically cannot fall out when tension drops. No babysitter required. It also accepts a cow hitch extension, so you can park farther from the stuck vehicle and reduce how often you have to stop and re-rig. Machined from USA Kiser billet 6061 aircraft aluminum in Burley, Idaho Type III hard anodized finish in gun metal gray, toughest available MBS 79,590 lbs+ pull-apart tested 2.2 lbs per ring; two rings replace 4 snatch blocks and 5 hard shackles Offset hole allows through-hole rigging on 2:1 setups so the line stays put under slack Accepts cow hitch winch line extension for fewer re-rigging stops mid-recovery Compatible with HMPE winch line up to 7/16" diameter only, never steel cable Zero corrosion, zero bearing maintenance Laser engraved, machined and anodized in Southern Idaho MBS 79,590 lbs+ Max Winch Rating 12,000 lbs (electric bumper-mounted only) Max Line Diameter 7/16" HMPE synthetic only, never steel cable Total Diameter 5" Groove Diameter 3-1/4" Hole Radius 2-1/4" Max Pull Configuration 5:1 (4:1 requires 2 rings, safety catch sling, and double loop soft shackles) Friction Loss at Peak Load ~10% Weight 2.2 lbs Material 6061 aircraft aluminum, Type III hard anodized Origin Machined and anodized in Southern Idaho Machined and anodized in Southern Idaho. American-made, start to finish. Specifications SPECIFICATIONS Type III Hard Anodized Finish in Gun Metal Gray. USA Kiser billet 6061 Aircraft Aluminum. Machined in Idaho. Anodized in Idaho. 2.2 lbs  5" total diameter. 3 1/4" groove diameter (8x 3/8" winch line radius transit+). 2-1/4" hole radius.  (6x 3/8" winch line radius transit).  Current "pull apart" MBS 79,590 lbs+ Patent Pending Shipping SHIPPING We pay for shipping on orders over $200!! US Standard rates only Expedited & International shipping services are available for an additional cost at checkout Orders ship within 3-5 business days Local pickup available at YR Headquarters, ready in 24 hours during normal business hours