O Ring OR00200100-1

This O-ring (Part # OR00200100-1) is a genuine replacement seal specified for use in the KUPA KP-55A/KP-60 handpiece. It is designed to restore proper seal integrity, prevent ingress of dust, debris or lubricant leakage, and help maintain smooth performance of the internal spindle/shaft assembly. Features Helps maintain tool longevity by preventing contaminants from entering the high-speed internal assembly, which can otherwise accelerate wear on bearings or spindle. Supports smooth operation by preserving correct internal pressure and lubrication environment for rotating components. Cost-effective maintenance: A small part but important for preserving performance; replacing a worn O-ring can prevent larger repairs. OEM part: Ensures correct dimensions, material and fit — using the wrong seal can lead to improper operation or additional wear. Installation Tips Confirm the existing O-ring in your unit is the same part number (OR00200100-1) or an equivalent replacement. Inspect the seating groove and surrounding surfaces for damage, debris or wear — a new O-ring in a damaged housing may not seal properly. Unplug the handpiece and ensure it’s powered off and fully stopped. Disassemble the front housing / spindle area to access the existing O-ring. Remove the old O-ring, clean the groove and adjacent surfaces of any residue, metal shavings or lubricant build-up. Insert the new O-ring from the pack (one of the 4) into the correct location, ensuring it is seated evenly and not twisted. Re-assemble the handpiece and perform a low-speed (no bit) test to ensure smooth operation and verify there is no abnormal vibration or noise.