Nude Shimmer Acrylic Powder – LBS

Instructions Dip brush in to the Nomma Plus Liquid and drag the brush in any color DeEnti Acrylic Powder. Place the ball of the product on the nail and begin to sculpt. Acrylic Application 1. Sterilize Tools and Nail Station. Remove any additional residue or enhancement on nails if necessary. 2. Prep Your Nails: Clean, file, and buff your nails. Push back cuticles and remove any oils with PH Plus Bonder. 3. Primer Application (Optional): Use primer to promote stronger & longer lasting manicure. 4. Pour Nomma Plus Monomer into a Dappen Dish. Fluff powder in a Jar. 5. Dip brush bristles into the liquid. Wipe excess liquid on the dish to remove too much liquid on the surface of the bristles. 6. Dip the brush into the Acrylic Powder & wait for the bead to form on the brush. Tip: Too dry of a bead will not melt evenly and too wet of a bead will run. 7. Apply the bead of acrylic to the center of the nail and sculpt out evenly from side to side, and down the tip of the nail. Repeat as needed for additional coverage. Tip: Sculpt the nail in three zones. Mix ratio of 1.5 parts liquid to 1 part powder. 8. Repeat Steps until full set has been created. 9. Give time for nails to dry. Standard setting powders typically dry between 5-8 minutes. 10. File for shape. 11. Optional: Apply Dual Sealer as a Top Coat for an extra shiny finish. Dual Sealer is a Universal Top Coat that is cured under a LED/UV light. Dip Application 1. Apply a thin coat of PH Plus Bonder 2. Apply a thin layer of Thin Resin or Medium Resin. Wipe away any resin that may have gotten on your clients skin. Tip: All of our Dip Resin are interchangeable but we recommend using Thin as the Base, Thick as the Top and Medium as the Base or Top. 3. With the lid still on, shake the Powder jar to fluff up the powder 4. Create a base layer using Adv Gel Clear Powder to avoid any pigment staining on the Nailbed. Dip the wet nail directly into the freshly fluffed dip powder. 5. Gently knock or tap the bottom of the finger to let excess powder fall off. Repeat on all Nails. With a fluffy brush, wipe off nails and skin of excess powder. Tip: Insert the nail into the powder at a 45 degree angle to avoid clumping of powder on the nail 6. Repeat Steps 2-4 with desired colored powder 2-3 times until you get the coverage you desired. 7. Once the color has been applied, use a small amount of Harden Fast Dip Activator over the top of the powder. 8. Buff & File for shape & Length 9. Apply a thin, smooth layer of Medium or Thick Dip Resin and allow it to air dry without use of the activator. This will take approximately 4-5 minutes to cure with a shiny finish. Optional: Skip the Resin as a Top Coat and use Dual Sealer for a high Shine Finish. 10. Moisturize hands with Massage Butter and wipe nails down with a lint-free wipe and apply Cuticle Oil for nourishment to the cuticles and nail bed. Pro Tips Use in a ventilated area. All-in-one Acrylic & Dip Powder, This powder can be used for Acrylic sets or with a Dip System. No Lights needed. For better results use with DeEnti Nomma Plus Liquid. Is the powder drying too fast? try a standard set speed. Is the powder drying too slow? Try a fast setting powder.