Novatek HDSH3 -Short Sc.Hammer Shroud – PHS3VSEHDS

Novatek Shrouded HD Triple Scaling Hammer VSE (Short Handle) for Dust-Controlled Work in Tight QuartersThe PHS3VSEHDS pairs the triple-piston scaling hammer with a vacuum shroud that captures debris and dust at the heads. It drives three tungsten carbide cruciform pistons at 2,500 blows per minute each, matching the open HD-SH3 output, while the shroud and port route material to a connected dust collector. The 9-inch handle keeps the tool compact for overhead, vertical, and confined work where dust containment is still required. VSE Triple Short Handle: Compact Three-Piston Tool with Dust CaptureThe shroud surrounds the three-head cluster and connects through a port to a vacuum or dust collector, pulling coating debris and abrasive dust away as the pistons work. The triple output clears flat area faster than the single VSE, while the 9-inch handle keeps the tool short for tank interiors, overhead beams, and confined positions. Two live air inlets allow inline or perpendicular handle setup, and the tool can be converted to an inline configuration for hard-to-reach areas by moving the side handle to the main handle. The screw-top cap and nylon brush seals carry over for field service. Vacuum shroud and port capture debris and dust at the three-head cluster for connection to a dust collector Three tungsten carbide cruciform pistons at 3 x 2,500 BPM, matching open HD-SH3 output 9-inch handle keeps the tool compact for overhead, vertical, and confined-space work with dust containment Converts to an inline configuration for hard-to-reach areas by moving the side handle to the main handle Two live air inlets allow inline or perpendicular handle setup Runs on 14 CFM, so size the compressor accordingly before deployment Screw-top cap and nylon brush seals support field service and reduce grit wear VSE Triple Short Handle Applications and EnvironmentsStructural steel: dust-controlled removal of pack rust, laminar rust, and high-build coatings on plate and weldments in confined and overhead positions. Marine: strips deck coatings and non-skid inside tanks and tight spaces with debris captured. Concrete: take-down and texturing of slab surfaces with silica dust routed to a collector; aggregate exposure with optional bush hammer heads. Specifications Part No. PHS3VSEHDS Configuration Shrouded triple head (VSE), short handle Dust Control Vacuum shroud with port for dust collector Head Type Tungsten carbide cruciform, single-piece pistons (bush hammer optional) Blows Per Minute 3 x 2,500 Air Consumption 14 CFM (408 lpm) Cylinder Bore 1.06 in (28 mm) Piston Stroke 1.04 in (26 mm) Air Inlets Two live inlets (inline or perpendicular handle) Handle Length 9 in (229 mm) Tool Weight 13 lbs (5.9 kg) Documents Manual