Novatek HD SH3 Long Handle - 1Pc Head – PHS3HDL

Novatek HD-SH3 Triple Scaling Hammer (Long Handle) for High-Output Coating and Rust RemovalThe HD-SH3 long-handle scaling hammer drives three tungsten carbide cruciform pistons at 2,500 blows per minute each, tripling the impact footprint of the single-head tool for faster take-down across flat area. Crews running structural steel repaints, marine deck recoats, and concrete prep use it on pack rust, laminar rust, thick mill scale, epoxy, and non-skid coatings. The 18-inch handle adds reach for deck, slab, and floor-level work. HD-SH3 Long Handle: Three-Piston Output with Extended ReachThree pistons firing at 3 x 2,500 BPM cover a wider strip per pass than the single head, so the triple clears large flat surfaces faster, at the cost of more air and added weight. Two live air inlets let the operator set the handle inline or perpendicular to match the work, and the long handle adds reach and a more upright stance over deck and slab. The screw-top cap opens each head for field piston replacement, and nylon brush seals wipe the pistons every stroke. Three tungsten carbide cruciform pistons at 3 x 2,500 BPM cover wider strips per pass than the single head 18-inch handle adds reach for deck, slab, and floor-level surfaces and a more upright stance Two live air inlets allow inline or perpendicular handle setup to suit the surface and work angle Higher output than the 1SH, suited to open flat area rather than tight edge work Runs on 14 CFM, so size the compressor accordingly before deployment Screw-top cap allows field replacement of heads and pistons Nylon brush seals clean each piston every stroke to reduce grit wear HD-SH3 Long Handle Applications and EnvironmentsStructural steel: clears pack rust, laminar rust, and high-build coatings across plate, decking, and large weldments. Marine: strips deck coatings, non-skid, and corrosion over broad deck areas. Concrete: rapid take-down of slab surfaces, plus texturing and aggregate exposure for bonding overlays when fitted with bush hammer heads. Specifications Part No. PHS3HDL Configuration Triple head, long handle Head Type Tungsten carbide cruciform, single-piece pistons (bush hammer optional) Blows Per Minute 3 x 2,500 Air Consumption 14 CFM (408 lpm) Cylinder Bore 1.06 in Piston Stroke 1.04 in Air Inlets Two live inlets (inline or perpendicular handle) Handle Length 18 in (457 mm) Tool Weight 14 lbs Documents Manual