Novatek HD-SH1 Short Handle - 1Pc Head – PHS1HDS

Novatek HD-SH1 Single Scaling Hammer (Short Handle) for Tight-Quarter Coating RemovalThe HD-SH1 short-handle scaling hammer drives one tungsten carbide cruciform piston at 2,500 blows per minute to fracture material that needle scalers cannot lift. The 9-inch handle keeps the tool compact for overhead, vertical, and confined work where a longer handle gets in the way. Crews running structural steel, marine, and concrete surface prep use it on pack rust, laminar rust, thick mill scale, epoxy, and non-skid coatings. HD-SH1 Short Handle: Compact Single-Piston Tool for Confined WorkThe single-piston head puts the full air charge into one impact point, giving close control along weld seams, edges, and fittings. The 9-inch handle, compared with the 18-inch long version, shortens the tool for tank interiors, beam webs, overhead beams, and other confined positions where reach matters less than handling. The screw-top cap opens for field head and piston replacement, and the nylon brush seal wipes the piston each stroke to extend life. One tungsten carbide cruciform piston at 2,500 BPM for controlled impact on edges, seams, and detail areas 9-inch handle keeps the tool compact for overhead, vertical, and confined-space work Runs on 6.5 CFM, supplied by one mid-size compressor through a full shift Single-piston head is narrow for work around bolts, flanges, and fittings Screw-top cap allows field replacement of the head and piston Nylon brush seal cleans the piston each stroke to reduce grit wear Optional tungsten carbide bush hammer head converts the tool for concrete texturing HD-SH1 Short Handle Applications and EnvironmentsStructural steel: removes pack rust, laminar rust, and high-build coatings from beams, plate, and weldments, including overhead and confined positions. Marine: strips deck coatings, non-skid, and corrosion in tanks and tight superstructure areas. Concrete: take-down of slab surfaces, plus texturing and aggregate exposure when fitted with the bush hammer head. Specifications Part No. PHS1HDS Configuration Single head, short handle Head Type Tungsten carbide cruciform, single-piece piston (bush hammer optional) Blows Per Minute 2,500 Air Consumption 6.5 CFM (186 lpm) Cylinder Bore 1.06 in Piston Stroke 1.04 in Handle Length 9 in (229 mm) Tool Weight 8 lbs Documents Manual