Novatek HD-SH1 Long Handle - 1Pc Head – PHS1HDL

Novatek HD-SH1 Single Scaling Hammer (Long Handle) for Heavy Coating and Rust RemovalThe HD-SH1 long-handle scaling hammer drives one tungsten carbide cruciform piston at 2,500 blows per minute, fracturing material that needle scalers leave behind. Crews running structural steel repaints, marine deck recoats, and concrete prep use it on pack rust, laminar rust, thick mill scale, epoxy, and non-skid coatings. The 18-inch handle adds standoff distance, so operators reach deck plate, beam webs, and floor-level work without bending over the tool. HD-SH1 Long Handle: Single-Piston Control with Extended ReachThe single-piston head concentrates the full air charge into one impact point, which gives the operator close control along edges, weld seams, and around fittings where a triple head is too wide. Choosing the long handle over the 9-inch short handle trades some maneuverability in tight quarters for reach and a more upright working posture on deck and slab surfaces. The screw-top cap opens for head and piston replacement without a press, and a nylon brush seal wipes the piston on every stroke to extend service life. One tungsten carbide cruciform piston at 2,500 BPM concentrates impact for edge work, weld seams, and detail areas 18-inch handle keeps the operator upright on deck and slab work and reaches floor-level surfaces without crouching Runs on 6.5 CFM, so one mid-size compressor can supply the tool through a full shift Single-piston layout is narrower than the triple head for work around bolts, flanges, and fittings Screw-top cap allows field replacement of the head and piston without removing the tool from service for long Nylon brush seal cleans the piston each stroke to reduce grit wear Optional tungsten carbide bush hammer head converts the tool for concrete texturing and aggregate exposure HD-SH1 Long Handle Applications and EnvironmentsStructural steel: removes pack rust, laminar rust, and high-build coatings from beams, plate, and weldments. Marine: strips deck coatings, non-skid, and corrosion on hulls and superstructure. Concrete: rapid take-down of slab surfaces, plus texturing and aggregate exposure for bonding overlays when fitted with the bush hammer head. Specifications Part No. PHS1HDL Configuration Single head, long handle Head Type Tungsten carbide cruciform, single-piece piston (bush hammer optional) Blows Per Minute 2,500 Air Consumption 6.5 CFM (186 lpm) Cylinder Bore 1.06 in Piston Stroke 1.04 in Handle Length 18 in (457 mm) Tool Weight 9 lbs Documents Manual