Novatek 12 In-Line Chisel Scaler – 12CS100

12 InLine Chisel Scaler for Tight-Access Coating RemovalThe 12CS100 is Novatek's most compact inline chisel scaler, sized for hand-held work in confined spaces where larger tools cannot reach. It drives a 1/2-inch square-shank chisel at 3,800 blows per minute to strip coatings, weld slag, and surface corrosion. All-steel construction holds up to repeated impact work on bridge steel, hull plate, and weld seams. 12CS100 Chisel and Tube ConfigurationThe tool ships with a 1/2-inch square-shank chisel holder and a 3/4-inch wide chisel as standard, and accepts 2-inch, 3-inch, and 2 3/8-inch bent chisels for wider passes or flush-cutting against obstructions. Reaches into pipe junctions and tank corners that block full-size scalers Strips mill scale and old paint at 3,800 blows per minute Runs on a small portable compressor through a 1/4-inch NPT air inlet Swaps to needle scaling in seconds when the surface profile changes Holds tolerance over long shifts with all-steel internal parts 12CS100 Applications and EnvironmentsShipyard and marine crews use the 12CS100 for spot descaling on hull plate, deck fittings, and weld prep where access is tight. Bridge and structural-steel contractors reach gusset plates and connection points, while abatement and restoration teams key concrete and clear corrosion ahead of recoating. Specifications Tool Type Inline chisel scaler Blows Per Minute 3,800 Chisel Holder 1/2 in square shank Standard Chisel 3/4 in wide Air Inlet 1/4 in NPT Documents Manual