MPA Weight Tuning System

The MPA Weight Tuning System was developed to give the shooter the ability to weight tune their MPA Chassis or rifle. This can be achieved by the addition of the entire weight system, or by using select weights for establishing desired balance points for their setup. If you are looking to improve your ability to spot impacts through weight enhancement, or simply want to change the balance point of your rifle assembly, our weight tuning kit is the ideal addition to your chassis. The weights can be purchased as a full kit (4 pieces), just the fore end weights (2 pieces), or just the rear weights (2 pieces). The Complete Weight Tuning Kit for the Matrix Chassis (Not Matrix Pro/Pro II) includes the following: Steel Round Buttstock Weight – 1 lb Front Fore-end Weight – 0.8 lbs Rear Fore-end Weight – 0.8 lb 8 Front Fore-end clamps 8 Button Head Cap Screws for the clamps Fastener for Attaching the Round Buttstock Weight The Complete Weight Tuning Kit for the full size BA/Comp Chassis & ESR Chassis includes the following: Steel Enhanced Bag Rider – 1.2 lbs Steel Monopod Weight – 1 lb Front Fore-end Weight – 1.2 lbs Rear Fore-end Weight – 1 lb 8 Front Fore-end clamps 8 Button Head Cap Screws for the clamps Fasteners for Attaching the Bag Rider and Monopod Weight The BA/Comp & ESR Chassis Fore-End Weight kit includes the following: Front Fore-end Weight – 1.2 lbs Rear Fore-end Weight – 1 lb 8 Front Fore-end clamps 8 Button Head Cap Screws for the clamps The Complete Weight Tuning Kit for the Hybrid Chassis includes the following: Steel Enhanced Bag Rider – 1.2 lbs Steel Monopod Weight – 1 lb Front Fore-end Weight – 0.6 lbs Rear Fore-end Weight – 0.7 lb 8 Front Fore-end clamps 8 Button Head Cap Screws for the clamps The Hybrid Chassis Fore-End Weight kit includes the following: Front Fore-end Weight – 0.6 lbs Rear Fore-end Weight – 0.7 lb 8 Front Fore-end clamps 8 Button Head Cap Screws for the clamps The Buttstock Weight Kit (compatible with the BA, Comp, ESR, and Hybrid) includes the following:  Steel Enhanced Bag Rider – 1.2 lbs Steel Monopod Weight – 1 lb Fasteners for Attaching the Bag Rider and Monopod Weight Please allow approximately 1-2 weeks for shipment for any action inlet EXCEPT for Remington Short Action. The fore end weights in the full size kit are NOT compatible with: Savage Long action inlet chassis Older style chassis: If your chassis looks like the one shown in the image (pay close attention to the radius rib pictured), then it will work with the fore end weights. Please keep in mind we will be adding the older chassis configuration to our offering, so please check back often.  Both rear weights are not compatible with all our chassis, The Ultra Lite WITHOUT the side folder is not compatible. The Ultra Lite side folder is compatible. Please contact MPA if you’re unsure whether your chassis is compatible with this item and we will be happy to assist you.