Motogadget mo.button

mo.Button Another innovation from Motogadget: the mo.Button. It's a big help - in combination with the new mo.unit blue - in reducing 'cable clutter' and simplifying wiring harnesses. Integrated into the handlebar tube - or any other adequate location - this tiny cylinder will electrically connect all handlebar instruments, switches and buttons. Using state-of-the-art bus technology, the m-Button digitally processes signals and transmits them to the mo.unit blue over a thin cable. The electrical consumers will then be switched inside the m-Unit. All control wires are moved into the handlebar. This saves space, weight, labor and time. A 'must have' for custom bikes with clean-look handlebars. In simple facts: a) normally, the operating current (e.g. headlight or turn signals) is transmitted directly via the wiring of the handlebar switches. Due to the high currents, cables with large cross-sections have to be routed from the fuse box to the switch and back to the electrical consumer.  The result: big cable bundles. Definitely, a 'no go' for custom bikes with restricted space or a concealed electrical system. b) using the mo.unit without the mo.Button, just a thin cable for each switch- or button-controlled feature has to be routed to the mo.Unit. These cables only carry minute control currents. All high loads and currents are switched directly at the m-Unit and transmitted directly to the electrical consumers. This already leads to a significant reduction and simplification of the wiring harness. Using the mo.Unit blue in combination with the tiny mo.Button, you will once again reduce the amount of cables that have to be routed! All switches/buttons on the handlebar are connected at the shortest distance possible and concealed inside the handlebar. Consequently, you will have to route only ONE thin cable from the mo-Button to the mo.Unit. All loads and currents will be switched directly at the mo.Unit blue (see explanations above). A layout reduced to the max! The mo.Button is completely molded in, making it water-tight and resistant to vibrations. Specs The mo.button has connections for - Left turn signal - Right turn signal - Light (alternating between low beam and high beam) - Electric Start - Horn - Front brake light switch Dimensions Diameter: 12 mm Length: 25 mm The cables have a length of about 60 cm. The cable to the mo-unit is 200 cm long. Weight about 30 gr Please note that the mo.Button can be used only with the mo.Unit blue.     Usually ships in 4-6 days