Maximum Controls - MAX ULTRA ARM Replacement Linear Actuator

Replacement Linear Actuator for Maximum Controls Swing Gates The Maximum Controls MAX Ultra Arm actuator is the direct replacement linear arm for MAX Ultra Arm swing gate operator installations. Made in the USA, the actuator is driven by a 24V DC motor through a direct gear drive with a 2 in tubular stainless steel output shaft and no internal chains, belts, or pulleys. The powder coated aluminum housing provides corrosion protection for outdoor installations. Stroke extends from a minimum of 39.1 in to a maximum of 60.3 in. Gate capacity scales with leaf length: 1,600 lbs at 8 ft, 1,200 lbs at 12 ft, 800 lbs at 16 ft, and 600 lbs at 18 ft. Both push-open and pull-open installation orientations are supported. The actuator includes a built-in two limit switch system with independently adjustable mechanical limit switches and slow-down switches for controlling gate position and deceleration at both endpoints. Mechanical and electrical gate release functions are built in with key-activated manual release. The actuator is rated for continuous duty operation from -4°F to 165°F (-20°C to +74°C) without a heater. Key Features Direct replacement linear actuator for MAX Ultra Arm swing gate operator installations; made in the USA with 24V DC motor and direct gear drive. 2 in tubular stainless steel output shaft; powder coated aluminum housing; no internal chains, belts, or pulleys. Stroke range 39.1 in to 60.3 in. Built-in two limit switch system with independently adjustable mechanical limit switches and slow-down switches for precise open and close positioning. Supports push-open and pull-open installation orientations. Continuous duty rated from -4°F to 165°F (-20°C to +74°C) without a heater. Technical Specifications Model: MAX Ultra Arm Actuator Manufacturer: Maximum Controls LLC (Made in USA) Motor: 24V DC Drive System: Direct gear drive; 2 in tubular stainless steel output shaft Housing: Powder coated aluminum Actuator Stroke: Min 39.1 in (993.5 mm) / Max 60.3 in +/- 0.39 in (1,531 mm +/- 10 mm) Nominal Thrust: 5,500 N Maximum Operating Current: 6A for max 10 seconds Gate Capacity: 1,600 lbs at 8 ft / 1,200 lbs at 12 ft / 800 lbs at 16 ft / 600 lbs at 18 ft Installation Options: Push open or pull open Limit System: Built-in two mechanical limit switches with adjustable slow-down switches Operating Temperature: -4°F to 165°F (-20°C to +74°C) Actuator Shipping Weight: 27 lbs Compliance: UL 325/991 Class I, II, III, IV; UL 2018; CSA; ETL listed Warranty: 2 years or 100,000 cycles, whichever comes first Condition: New Conclusion This listing is for the MAX Ultra Arm actuator only. The MAX AC Control Box is required for operation and is not included. If the existing control box and wiring are intact and functional, this actuator installs directly as a replacement. After installation, adjust limit switch positions on the actuator and cycle the gate open and closed several times to confirm positioning before finalizing limit and slow-down settings. Confirm your gate leaf dimensions and weight against the capacity chart before ordering. For installations requiring a complete operator system, the full MAX Ultra Arm kit is available separately. Warranty coverage applies only to products purchased through authorized distributors. Cut Sheet Installation / User Manual