POLARIS MATRYX EXO FRONT BUMPER

Our Polaris Matryx EXO front bumper comes loaded with unique features inside while keeping a clean minimal/slim profile on the outside. Our bumpers all have tig welded aluminum caps on the main tube to eliminate the need for plastic end caps. This gives the bumpers a clean look without the worry of losing the end caps.  On the inside we have added features that other companies often overlook. -Our unique cross tube provides noticeable torsional rigidity. -The mounting bracket for the stock belt holder is designed with the same profile as the original bumper. This gives you a nice tight fit just as it was from the factory.  - Where the bumper exits the plastics we have press formed the tubing to allow the 1" tubing pass through without distorting how the body panels fit. This is done by pressing each side of the tube separately to offset the press marks. Also, On the inner press mark we install a rivet-nut to accept the factory hardware that holds the belly pan to the bumper.  Exterior features include the following, -Slim minimal profile. -Ample room to grab and lift. No flat plate or sharp edges.  -Weld capped and slash cut tube ends to eliminate the cheap plastic caps. -Lower tubes are joined at the bottom to allow them to reach below the machine. -We have designed this to work with or without a skid plate.   Fits all Matryx Chassis NA and Boost