Lutron Diva 0-10V Single Pole/3 Way Dimmer

The Lutron Diva 0-10V Single Pole/3 Way Dimmer has no wireless capability. It's just a standard wired dimmer. The only time you would use a switch like this is in your garage if you don’t want to deal with any app controls or wireless connections. This switch is for 0-10V fixtures. You'll need to run both your line voltage and 0-10V wiring from the dimmer to your lights; Perfect for hardwiring your Cree LS fixtures in the garage if you can handle the 0-10V wiring needed. Capability of setting up a 3-way switch by wiring up another one on the opposite side of the room. The slider on the right gives you precise control over the dimming preset. A physical slider means your setting sticks when you toggle the lights. Capacity-wise, it can handle up to 8A. That means you can control up to 10 Cree LS8 high-lumen output fixtures, each drawing 0.77A. Straight to the point, no frills, “Dummy Switch.” Get it if it fits your needs.  Technical Information Power Operating Voltage: 120–277 V~ 50/60 Hz Output Ratings: Switch rating of 8 A. 0–10 V control link for 50 mA maximum output (sink only). 0–10 V Control Link: 0–10 V control link is Class 1. Controls up to 25 ballasts or drivers (IEC 60929 Annex E.2 requires the ballast / driver to limit the current draw to 2.0 mA maximum). Performance Power pack cannot be used with DVSTV- models. Works with all ballasts and drivers that provide a current source compliant to IEC 60629 Annex E.2, and whose inrush current does not exceed NEMA410 standards for electronic ballast / driver loads of 8 A steady state current. Adjustable high-end and low-end trim for optimal dimming performance. Power failure memory: should power be interrupted, the control will return to its previously set level prior to the interruption when power is restored. Captive linear slider. Precise color matching. Product Documentation Lutron Diva 0-10V Single Pole/3 Way Dimmer Installation Guide