LH Stinger Bed Kit — Carbon Fiber Bed + Carriage Plates + 24V Polyimide Heater

The whole LH Stinger 200 mm bed stack in one order: the carbon fiber bed plate, both carriage plates and the polyimide heater that bonds underneath. Everything the Starter Kit ships for the bed — for a scratch build from the BOM, a re-bed or a spare. What's in the kit 1× LH Stinger Carbon Fiber Bed Kit — 200 × 200 × 3 mm plate plus the two 3 mm carriage plates, matte 3K Toray, cut to the official DXFs 1× LH Stinger 24V 200mm Polyimide Heater — flex-PCB heater with 3M adhesive and pre-soldered power leads How it goes together Epoxy the two carriage plates into one (Loctite Power Epoxy Universal or J-B Weld High Heat), file the belt holes smooth and keep the round spacers and strain-relief arms from the breakaway tabs. Bond the heater to the underside of the plate on the project's alignment jig and let the adhesive cure before the first heat-up. Print straight on the carbon; a PEI film is optional — the 192 mm cut of our 20mil Ultem PEI sheet fits. Gotchas No magnet, no spring steel in a Stinger bed stack — the carbon plate is the print surface. Carbon conducts: insulate the heater leads, short-test before power, and keep the bed at or under the project's 110°C limit. Not included: bed thermistor (a glass bead goes through the heater's round opening), XT60 connectors (XT60 pair), epoxy and fasteners. Same parts, same shelf as the singles linked above — if the kit reads sold out, one of its parts is.