OTTOeject MK1 Automated 3D Print Ejection System by LDO Motors

OTTOeject MK1 Automated 3D Print Ejection System Print bed automation from OTTOMAT3D, manufactured by LDO. The OTTOeject MK1 pulls the finished plate off your 3D printer, racks it in storage, and loads a clean bed so the next job can start without you standing there. Eject, Store, Load, Repeat When a job finishes, the gantry slides the plate out with the part still attached, sets it into the storage rack, and pulls a clean bed into position. The printer picks up from there and starts the next file on its own. Repeat that loop and one machine turns into an overnight production run. Stack up your jobs and the system works through them plate by plate, holding every finished print until you get back to it. Compatible with Most 3D Printers Tested on Bambu Lab, Prusa, Creality, Flashforge and Elegoo hardware The OTTOeject works alongside your existing printer, nothing you've already invested in goes to waste. OTTOMAT3D tests new models frequently and the compatibility list keeps growing. Enclosed machines are supported as well. The system can open and close the printer door as part of each cycle, so you are not restricted to open-frame designs. Confirmed working Bambu Lab A1, P1P, P1S, X1C Prusa MK3/S/+, MK4/S, CORE One, Switchwire Creality K1C, Ender 3 V3 Flashforge AD5X, 5M Pro Elegoo Centauri Carbon OTTOMAT3D adds new models on a rolling basis, so check back if yours is not listed yet. Sized to Your Bench Adjust placement, footprint and storage capacity Where the unit sits, how much room it takes up, and how many plates the rack holds are all yours to change. Keep it tight against a single printer where space is short, or extend the storage for longer unattended sessions that run without a break. The Full Cycle OTTOengine Software One interface for your printers, your jobs and your OTTOeject units OTTOengine is the control software behind the system. It handles smart queue management, monitors print jobs while they run, and communicates directly with both your printers and your OTTOeject hardware. Add a second or third machine and they stay coordinated from the same screen instead of each one needing its own attention. What's in the Kit SKR Pico Extrusions Motion System Electronics Power Supply Unit Stepper Motors Cable Chain Hardware Fasteners Checklist Assembly Guide OTTOMAT3D walks through the full build from the first extrusion to the finished machine. Frequently Asked Questions Will it work with my printer? Most FDM printers are compatible. The models listed above have been tested extensively and OTTOMAT3D continues to add more. My printer has a door rather than an open frame. Is that a problem? No. The OTTOeject opens and closes printer doors automatically as part of the cycle. Do I need technical skills to set it up? If you can set up a Bambu Lab or Prusa printer, no additional skills are needed. Can one system manage several printers? Yes. Multiple printers can be run simultaneously through OTTOengine, with documentation and any additional parts supplied as required. How much maintenance does it need? Very little, provided it has been set up correctly. Are more modules planned? Yes. OTTOMAT3D has further modules, features and designs in development.